![]() ![]() This is used so that all packets that have. When the TCP connection has been closed down, the connection enters the TIMEWAIT state, which is per default set to 2 minutes. ![]() In this case, the connection would be closed down immediately. I ran tcpdump, I see no ICMP unreachable packets, or any other suspicious looking packets. A connection may also, for example, be closed by sending a RST (reset), if the connection were to be refused. destination ports of the connection, and UNREPLIED refers to the. A udp connection is being destroyed before timeout. At this point the entry is marked ASSURED (once connections become ASSURED they are not dropped under heavy load ). udp 17 src=172.17.25.219 dst=172.17.29.133 sport=34087 dport=1194 packets=29 bytes=4349 src=172.17.29.133 dst=172.17.25.219 sport=1194 dport=34087 packets=27 bytes=3596 mark=581Īll this happens within 10 secs, so there is no chance for a timeout. If multiple requests and replies occur between the same socket pairs, the entry is considered to be a stream and the timeout changes to 180 seconds. UDP connections using various states, such as UNREPLIED and ASSURED as. We could either duplicate all of the ipv4 connection tracking code into an ipv6 counterpart, or (the choice taken by these patches) we could design a. So my load balancing doesn't work properly. And I see that a single connection from client side creates 2 connections on server. I was trying to load balance udp connections across 2 servers. ![]()
0 Comments
Leave a Reply. |